Badge 10 mm 2 m - Code: 52.190.10 - Osculati

Osculati 10 mm gasket 2 m – code 52.190.10

La Osculati gasket is a technical spare/consumable designed for typical uses in maintenance and restoration in the nautical and onboard system field. This item is offered in the format 10 mm and length 2 m, a practical combination for targeted interventions, replacements, and workshop work where it is useful to have a ready-to-use element without having to manage reels or excessive lengths.

Main data

• Type: gasket
• Diameter: 10 mm
• Length: 2 m
• Supplier product code: 52.190.10
• Supplier: Osculati S.r.l.

Identification and spare parts management

To reduce errors during procurement, it is advisable to always refer to the code 52.190.10 in requests for quotes, orders, and maintenance notes. In the nautical field, where similar but not equivalent components may coexist, the manufacturer's coding helps maintain consistency between the installed spare and the purchased spare.

Typical applications in the nautical field

The gasket is an element used in various activities of maintenance e restoration on boats and onboard systems. Specific applications depend on the component being worked on and the instructions of the manufacturer or the technician performing the work.

Routine maintenance and workshop interventions

• Scheduled replacement interventions of materials subject to wear.
• Restorations during work on mechanical components or system parts that require a gasket of the correct section.
• Preparation of spare parts to keep onboard for maintenance needs.

Format suitable for targeted interventions

Supply in 2 m is practical when you want to manage contained quantities, typical of specific interventions. It is a useful solution both for immediate use and as a stock, especially when you prefer to have material ready without having to cut from longer rolls.

Consistent choice with the required section

The diameter 10 mm allows you to select the product consistently with the intended application. In the technical field, the correct section is an essential criterion: for this reason, it is advisable to always check the size required by the component or installation site before purchase.

Usage and operational notes

The usage methods depend on the specific application and the procedures provided for the component being worked on. Below are some general guidelines useful for orderly management of the replacement.

Checks before installation

• Size check: verify that the requested diameter is actually 10 mm.
• Length check: assess if 2 m they are sufficient for the planned intervention, considering any waste or cuts.
• Comparison with the removed replacement: when possible, compare dimensions and configuration with the replaced material.

Cutting and preparation

If the application requires a portion shorter than the supplied length, it is possible to prepare the necessary quantity based on the intervention needs. For a neat result, it is advisable to cut with suitable tools and arrange the material to facilitate its placement according to the prescribed procedure.

Storage on board or in the warehouse

• Store the product in a clean container dedicated to spare parts.
• Label with code 52.190.10 for quick identification.
• Keep track of usage to plan reordering in time.

Important note

For specific applications on engines or critical components, follow the manufacturer's instructions and the prescribed maintenance procedures. In case of doubt about compatibility, it is advisable to identify the replacement via product code and verify the match with your requirement before installation.

FAQ – Frequently Asked Questions

What is the Osculati code for this fender?

The supplier product code is 52.190.10, useful for identification and reorder.

What are the dimensions of the banner?

The tape is 10 mm in diameter and is supplied in a length of 2 m.

In which contexts is this banner used?

It is a typical consumable/spare part for maintenance and restoration activities in the nautical field and onboard systems. The specific application depends on the component being worked on.

How can I check if it is suitable for my procedure?

Check that the requested size is 10 mm and that the length of 2 m is sufficient. When possible, also compare with the removed material or with the instructions from the manual/technician.

Who is the product supplier?

The indicated supplier is Osculati S.r.l.